Audiobus coming to foreground on midi command, GTL pushed to background
Hi all (and esp @Jack)
I am using GTL with Audiobus and a Korg nanoKontrol2 as the midi controller. I am using a few buttons and a couple faders of the Korg to send midi signals to Audiobus and the reset of the Korg buttons and faders are used for sending midi signals to GTL.
Somehow I have gotten in a mode where Audiobus gets pulled to the foreground whenever it receives midi signals from the Korg. So at the same time, GTL is getting pushed to the background - which is not what I want. I want to watch / monitor GTL during performance, so I need it to stay in the foreground. I am just using audiobus to independently control the volume of the inputs and to enable/disable the audio inputs going into GTL.
I had not had any issues with this until just recently. I think this is what happened - I was in GTL and got a pop-up which said something like "OK to switch to audiobus" and without thinking much I said yes. And since then Audiobus comes to the foreground on any midi signals it receives.
I cannot seem to find how to disable this mode or switch it back so that GTL always stays in the foreground. Any ideas?
I have a bunch of midi and key bindings defined in GTL and would prefer not to reinstall GTL as I believe I would lose all those. I don't mind reinstalling audiobus because I don't have many bindings there - that might be my next step.